A damaged O-ring on the filter housing of the Graco Airless sprayer can cause leakage and spillage on the filter housing. In the fourth part of our video series “Airless Q&A” we show you how you can replace the sealing ring in a few simple steps. In addition, we have created an overview below, so you can quickly select and order the required O-ring for your sprayer.

In the video we show the gasket change on the main filter of a Graco UltraMax II 795 standard. The replacement of the seal is also very similar for other models. In many Graco sprayers from the UltraMax II 695 to the Graco Mark VII and Mark X, the seal used in the video is also installed.

Overview O-ring for Graco main filter housing – select correct O-ring

Here is an overview of the matching O-ring for the main filter housing of the current Graco sprayers:

  • Order Graco Classic 390 PC – O-ring directly – click here
  • Order Graco Classic S 395 PC – O-ring directly – click here
  • Order Graco Classic S 495 PC – O-ring directly – click here
  • Order Graco ST MAX II 395 PC Pro – O-Ring directly – click here
  • Order Graco ST MAX II 495 PC Pro – O-ring directly – click here
  • Order Graco ST MAX II 595 PC Pro – O-ring directly – click here
  • Order Graco UltraMax II 695 – O-ring directly – click here
  • Order Graco UltraMax II 795 – O-ring directly – click here
  • Order Graco UltraMax II 1095 – O-ring directly – click here
  • Order Graco Mark V – O-ring directly – click here
  • Order Graco Mark VII – O-ring directly – click here
  • Order Graco Mark X – O-ring directly – click here

For any further questions or if you would like to get your hands on one of these products seen in this article, you can contact us on +49 (0) 30 220 15436, fill out our contact form below or email us. If you wish to purchase one of the products mentioned above, you can check them out in our online store. You can also visit us at our service base during office hours.